Filling Machines

The decision comes down to your product's physical form. Piston fillers handle liquids, creams, and pastes, including recipes with soft particulates, while auger fillers are built for powders and granules. If you run both product types, some producers keep one of each rather than forcing a single machine to compromise.

Well set up volumetric and piston fillers typically hold fills within half a percent to one percent of target, while auger fillers on stable powders achieve similar results with checkweigher feedback. Accuracy depends heavily on consistent product temperature, viscosity, and bulk density. Ask sellers for real fill data from the machine rather than relying on theoretical figures.

Inspect product contact parts for wear and pitting, check seals and O rings, and confirm the machine strips down easily for cleaning. Watch it cycle, ideally with water or your own product, and note any drips or inconsistent shots. Confirm which nozzles and change parts are included, because missing format parts can cost more than expected to replace.

Many piston and gravity fillers are rated for hot fill temperatures of 85 to 95 degrees Celsius, but seals, hoppers, and nozzles must be specified for it. Verify the machine's temperature rating and ask what products it previously ran hot. Undersized seals on a machine used only for ambient products will fail quickly on a hot line.

Financing applies to qualifying filler listings, letting you match repayments to the revenue the machine generates. This suits growing producers who need accuracy and speed now rather than after another year of saving. The listing page or a direct conversation with the seller will confirm eligibility.