Pallet Lifts and Lift Tables

Rate the table for your heaviest load plus a margin, and check the load's footprint against the platform, because capacity assumes an evenly distributed load. Off-centre or edge loading de-rates the table, often by half. Confirm raised and closed heights against your working level and loading method, and give the seller the full duty cycle.

It depends on how the table is loaded. A forklift can load a standard table from above, but a hand pallet truck needs either a pit-mounted table flush with the floor, a ramp, or an ultra-low model that collapses to pallet-truck height. Ultra-low tables avoid civil works entirely, which usually makes them the cheapest installed option.

Watch the table drift: raise it loaded and see whether it creeps down, which points to worn seals or valves. Inspect scissor pivot pins and bushes for play, hoses for weeping, and the platform for distortion. Ask when seals were last replaced and whether a report of thorough examination comes with the machine.

If operators walk around pallets to pick or stack, yes. A rotary top brings each face of the load to the operator, cutting the walking and twisting out of pallet work; the 3,000 kg rotary models listed here handle full pallets. If loads are only raised and lowered between machines, a fixed top does the job for less.

Most hydraulic scissor tables run on a three-phase supply, though single-phase and battery-powered units exist for lighter duties and mobile use. Check the motor rating on the listing against the supply at the installation point, and remember battery models need a charging point and routine. The seller can confirm voltage and plug arrangement before you commit.